This procedure sets the working mode of the TFT, that is, how the display receives information from the controller.
Mode by controller
| Controller | Mode to set |
|---|---|
| VEGA | Serial V |
| Addtech | Binary or RS485ADD |
| Infolev | Binary |
| Schmersal | GRAY |
| Scanchip | Binary or RS485 SCAN |
If you have any doubts about which mode to use, contact technical support.
Menu to use
The procedure is the same for all displays: only the menu changes.
| Display | Menu | Where to find it |
|---|---|---|
| TFT 7" (TFT7xxS) | 1.2 | General menu → 1 Mode and project → 1.2 Set mode |
The joystick
On the back of the TFT there is a programming joystick: it moves in all directions, holding it down opens the menu, pressing it confirms.
Procedure
- Hold the joystick down until the general menu opens.
- Open the menu shown in the table (in the video: 1 Mode and project → 1.2 Set mode).
- Move the joystick up or down to your controller's mode (see the table).
- Confirm and go back to the home screen.